4. Version 0.8

   Version 0.6, 0.7, and 0.8 of Gnuk has been released.

   Highlights are:

   • Experimental PIN-pad modification support is added.

     PIN input using rotally encoder and push switch is tested with STBee Mini. By this hardware, PIN-pad modification is supported.

   • Experimental PIN-pad support is added.

     Local PIN-pad input is …

   read more

5. Infra-Red remote controller (TOSHIBA)

   The IR controller which comes with Toshiba REGZA TV is tested with Gnuk.

   The protocol is so-called "NEC Protocol". The frame is composed like: START-bit, 32-bit data, and STOP-bit. The 32-bit data is: 8-bit command inverted + 8-bit command + 16-bit address.

   Here is the table of code and button.

   code	button …

   read more

6. Infra-Red remote controller (DELL)

   The IR controller which comes with Dell Vostro is supported by Gnuk.

   Its protocol is Phillips RC-6.

   Here is the table of code and button.

   code	button
   0x10	Speaker Loud
   0x11	Speaker Quiet
   0x0d	Speaker Mute
   0xce	▲
   0xcf	▼
   0x58	△
   0x5a	◁
   0x5c	✓
   0x59	▽
   0x5b	▷
   0xa4	⇦
   0x2f	◀◀
   0x2c	▶/Ⅱ
   0x2e	▶▶
   0x21	｜◀
   0x31 …

   read more

7. PIN input support for STM8S Discovery Kit

   At Akiduki Denshi, you can buy consumer Infra Red Modules.

   Gniibe bought PL-IRM-2161-C438 (100.- JPY for two modules), and connect one to STM32 part of STM8S Discovery Kit. We can input PIN with IR remote controller.

   Since IR signal is easily monitored, it is not secure at all. This is …

   read more

8. Version 0.5

   Version 0.5 of Gnuk has been released.

   Highlights are:

   • New board support: STM32 part of "STM8S Discovery"

     We can buy it at 750JPY in Japan (10USD or so internationally?). I think that it is most cheap board for Gnuk.

   • Better interoperability

     • In-stock GPG ccid-driver
       • Although in-stock GPG ccid-driver doesn't …

   read more

⇇ « Page 15 / 18 » ⇉